Change a Propane Tank
Propane fueled forklifts are normally utilized in warehouses. The forklift is designed with the propane tank mounted at the rear of the driver. The tanks, that look a lot like beer kegs, have to be replaced periodically since they have a limited lifespan. Forklift drivers must utilize caution when handling propane tanks. Compressed gases are very hazardous, specially since the gas is flammable. Use care when replacing and removing propane tank to avoid injury.
1 If there is a need to change the propane tank, the first step is to stop the lift truck, then turn off the tank valve. The forklift should be left on until the engine dies. This procedure burns the gas off in the transfer hose that connects the tank and the engine. Before taking the second steps, wear the proper safety equipment, like insulated gloves made of either leather or neoprene. It is very important for you to protect your skin from contact with the compressed gas, that is very cold.
2 The tank hose has to be disconnected, followed by removing the tank from its holding straps. When putting in a new tank, reattach the holding straps and reattach the hose at the valve of the tank by tightening the nut.
3 Leaks could be checked just by applying soapy water to the valve and slightly opening it. If there is a leak, it would cause bubbles to foam from around the valve. If this happens, check the valve area and the connection hose at the nut. Re-tighten the connecting nut if you detect any leaks around the valve area, and afterward do the leak inspection procedure over again. Persistent leaks mean that the nut and connecting hose should be replaced. However, if replacing the hose and nut still does not stop the leak, the tank must be replaced.
4 Open the valve all the way to allow the gas to fill the connecting hose. Then you can start the forklift and resume operating.